Running IRL SLAM Studio on a low-cost sensor setup

Lab News ยท

Description

We’ve been running IRL SLAM Studio on a low-cost sensor setup:๐Ÿ“ทIntel RealSense D435i (~$300โ€“500), using only its built-in IMU๐Ÿ›ฐ๏ธu-blox ZED-F9P-04B GNSS RTK receiver (~$150 for a breakout board)That’s a full visual-inertial + RTK GNSS kit for well under $1,000.
What the system does:๐Ÿ”Without GPS: visual-inertial odometry with loop closure, which corrects the drift that builds up in the pose over time๐Ÿ›ฐ๏ธWith GPS fused: keeps running smoothly even when the GPS signal is lostโšกGPS arrives at only ~2.5 Hz, but IRL SLAM Studio outputs 100 Hz odometryIn the video: one quadruped run of ~340 m, the same data processed in four configurations (camera IMU vs. external IMU, with and without GPS). Midway through, RTK GPS degrades for 106 s. The GPS-fused configurations ride through it and finish with an ATE of 0.12โ€“0.13 m against the RTK ground truth.
Low-cost hardware, reliable results, ready for real robots.
Intelligent Robots Lab, Chungbuk National University